Specifications

26
in.xe™
Shut electrical power off.
Turn power on.
At power-up the in.xe™ system
will upload all the different
configurations set into the
in.stik™ memory.
The in.xe™ will then enter the
low-level configuration menu.
The keypad display will show
L xx where "xx" represents the
previous configuration number
registered in the system.
Use the Up/Down key to
choose the new desired low
level configuration number.
Press the Prog. key to confirm
the selected configuration
(consult the configuration.
If the Prog. key is not pressed
within 25 seconds, the unit will
exit this menu without changing
any settings.
programming the in.xe™
Note: If the keypad in use does
not have the Prog. key, use
Light key instead.
If at power-up of the system
your keypad display shows
the following message:
"L _ _
", it means that all low
level configurations have
been downloaded, but no
configuration number has
been chosen.
Programming the in.xe™
using the in.stik™
This feature is very useful on
production lines to configure
packs and in the field for service
purposes like software updates.
Follow these simple steps to
upload new pre-determined
low level program configura-
tions into the spa pack.
Insert the in.stik™ in the
communication connector
(see fig. above).