Owner`s manual

Connecting ZO-300/302: Insert lamp cartridge straight into power supply,

being careful to align pins, and bonding plate (on back). Press power supply

and lamp cartridge together. CAUTION: DO NOT TWIST cartridges while

pushing them together. Twisting will damage the OZONE GENERATOR which

could lead to premature failure. Attach the two cartridges by securing the

bonding plate to the lamp cartridge. Use the included self-tapping screw and

star washer.

INSTALLATION

MOUNTING

Find a suitable location to mount the ozone generator. To prevent water from

backing up into the ozone generator, it should be secured one (1) foot above

the spa’s water level and at least five (5) feet away from the water, out of

arm’s reach. Locate the unit so that electrical and ozone supply tubing

connections can be made easily. The ozone generator must be mounted

indoors or under a cover, protected from natural elements. The unit may be

mounted under the spa’s skirt by utilizing a Hartford Loop (see page 11).

NOTE: If the ozone generator is used on an indoor spa, the room needs to

have adequate ventilation.

SpaECLIPSE/CDS-16: Attach the unit to a solid surface using screws

(included).

ZO-300/320/301: The recommended mounting direction is with the tube

horizontal; however, it may be mounted vertically, with the power cord up.

Attach the mounting clamps to a solid surface with screws provided. Snap the

generator into the mounting clips by inserting one leg first and then rotating

the unit until it locks into place. Each clip should be centered on a cartridge.

OZONE SUPPLY TUBING

Your ozone generator includes 5’ of tubing. Cut the tubing 4’ from the ozone

generator. Insert the check valve between the cut to reconnect the pieces.

The check valve permits ozone to flow through in one direction while prevent-

ing water from backing up into the ozone generator. You can test the direction

by blowing through one end of the check valve (air will only flow through from

one end). There are various locations to which the other end of the ozone

supply tubing can be connected to a spa that is not ozone ready. Review the

following section to determine which location is most suitable.