Instruction manual

Spa Operator’s Guide
36
SPA TERMINOLOGY
GATE VALVES
Are installed for shut off/on water supply from heater or pump for service.
For normal spa operation valves should be in the open position. (handle
extended is open).
MAIN PUMP
This produces water flow through heater and main jets. Also used for
filtration. Can be controlled as desired by pressing the pump or pump 1
button on your topside control panel. (refer to Quick Reference Card) for
filtration frequency and duration.
SECONDARY PUMP (on select models)
This produces water flow through secondary group of jets. This is pump
could be a 1 or 2 speeds. Can be controlled by pressing the pump 2 button
on your topside control panel.
THIRD PUMP (on select models)
This produces water flow through third group of jets. This is pump will be a
high speed only. Can be controlled by pressing the pump 3 button on your
topside control panel.
CIRCULATION (on select models)
If equipped this pump is controlled during filtration and heating only, by the
topside control configuration. (refer to Quick Reference Card) for filtration
frequency and duration.
OZONATOR (on select models)
If equipped will run for 45 minutes during filtration cycle. Helps reduce
chemicals/santizer use. (automatically cuts-off if any user buttons are
pressed on topside control, will reactivate during the filtration cycle).