Instruction Manual

NOTE: PLEASE CHECK YOUR UNIT TO MAKE
SURE YOU ARE FILLING WITH THE CORRECT
TYPE OF SOAP OR SANITIZER.
x1
1-888-946-2682 | [e-mail]
www.wincous.com
Manual Soap Dispenser
SDML-1W
SDML-1K
SDMF-1W
SDMF-1K
MOUNTING THE DISPENSER
OPTION 1: DOUBLE-SIDED ADHESIVE
OPTION 2: MOUNTING HARDWARE
FILLING THE DISPENSER
1. Open the unit by pressing the button located at
the top-rear of the dispenser (Fig.2).
NOTE: the key will be required if unit was
locked with the key (Fig. 1).
2. Unscrew the cap (Fig.3) and fill the container
with soap.
3. Reinstall the cap loosely and close the unit.
4. To prep the pump for dispensing, press the
pump bar approximately 10-20 times until it
begins to dispense. Repeat for each refill.
1. Open the unit by pressing the button located at
the top-rear of the dispenser (Fig.1).
2. Remove soap container prior to mounting.
3. Place the dispenser on desired wall location.
3. Mark and install wall anchors.
4. Mount using screws and washers.
5. Re-install the soap container.
1. Place double-sided self-stick adhesive strips on
back of unit and stick onto wall.
BUTTON
TO OPEN
(Fig. 1)
x3
x3
x3
BUTTON
TO OPEN
(Fig. 2)
CAP FOR
SOAP
CONTAINER
(Fig. 3)
FOAM = LARGE TUBELIQUID / GEL = SMALL TUBE
09/2020
LOCKING THE UNIT (OPTIONAL)
1. Close the dispenser.
2. Insert locking key (included) into the button
located at the top-rear of the dispenser (Fig.1).
3. Turn key to lock unit.
For best results, adhere
to a smooth surface
that is clean and dry.
To clean, wipe surface
until dry and use
rubbing alcohol to clean
the surface.