Specifications

n
Follow the instructions from the host computer. The printer begins
printing.
n
Remove the form or check after it has been ejected.
n
Follow the instructions from the host computer to finish the transaction.
Dro pin me thod
n
In sert the form or check (as shown on the right abo ve) into the slot from
the top or side with the print side to ward you. A slight re sis tan ce may be
felt when the form co mes in con tact with the form stop.
n
Move the form or check to the right un til it is alig ned against the right edge
of the slot.
n
Slide the form or check downward until the green slipin light on the top
cover turns on. This indicates that both sensors are covered.
n
Follow the instructions from the host computer. The printer begins
printing.
n
Remove the form or check after it has been fed back out.
n
Follow the instructions from the host computer to finish the transaction.
See the next page for proper insertion of multi-part forms.
Pro per in ser ti on of mul ti-part forms
Be sure to insert multi-part forms glued-edge-first as shown in the drawings
on this page, whether inserting the form from the front, top or side.
Failure to insert multi-forms properly can result in costly paper jams and
damage to the form.
37
PRINTING ON FORMS OR CHECKS