Specifications

To run the data sco pe mode
n
After you have enabled the data scope mode, exit the configuration menu.
n
Run a transaction from the BEETLE or host computer.
All commands and data sent from the BEETLE/host computer will be printed
as hexadecimal characters as shown in the illustration.
To exit the data sco pe mode
n
Enter the configuration menu again.
See “Configuring the printer.”.
n
Disable the data scope mode.
n
Exit the configuration menu.
The printer is once again on-line and can communicate normally with the
host computer.
En ab le or dis ab le re ceipt test mode
The receipt test mode verifies proper receipt printing. Receipt test is
enabled and disabled by selecting the “Diagnostic Modes” sub-menu of the
configuration menu. See “Configuring the printer” for instructions on how to
enter the configuration menu.
To exit the re ceipt test mode
n
Enter the configuration menu again. (See “Configuring the printer”)
n
Disable the receipt test mode.
n
Exit the configuration menu.
n
The printer is on-line and can again communicate normally with the host
computer.
To run the Re ceipt test mode
n
Enable the receipt test mode in the configuration menu.
n
Exit the configuration menu.
n
Push the paper feed button. The receipt station prints two code pages
and cuts the receipt.
n
To repeat this test, push the paper feed button again.
En ab le or dis ab le slip test mode
The slip test mode verifies proper printing on a slip. Slip test is enabled or
disabled by selecting the “Diagnostic Modes” sub-menu of the configuration
menu. See “Configuring the printer” for instructions on how to enter the
configuration menu.
31
DIAGNOSTIC MODES