Specifications

Programmers Guide TH230/TH230+
270
Printer Settings:
• Black Mark Sensor: enabled / disabled
• Endurance Test: enabled / disabled
• Automatic linefeed: enabled / disabled
• Power button: enabled / disabled
• Power-ON Notice: enabled / disabled
• Paper- NE Notice: enabled / disabled
• Receipt Shooting: enabled / disabled
• Shoot Flush Time: timeout before start the receipt shooting [sec]
• Sleep Mode: enabled / disabled
• Max. power: value of max. Power
• Max. speed: “xxx mm/sec”
• Nr. of endurance tickets Number
• Paper width “xx mm”
• Print density value of density
• Paper type single color / two color
• Code-128 ChkDigit Check Digit in 128 Barcode - enabled/disabled
• ITF Leading Zero Leading Zero in ITF Barcode - enabled/disabled
• Brc String Term Barcode String Termination - enabled/disabled
• Legacy Printer Support enabled / disabled
• Listen to RT-Cmds Always / BufNotFull
• Default Code Page 0 - 255
• Auto Recovery off / on
• Orig.-Controller yes / no
Sleep Mode: (optional)
• Waiting Time: timeout before switch to Sleep Mode
• Interface Power: power of cash drawer and display (only TH230+)
• Cash Drawer Delay: time from interface power on to open cash drawer
Color Settings: (optional)
• Color Density value of color print density
*** TWO COLOR PRINT ***
Sensor Informations:
Sensor Plug Detection
• Black Mark Sensor Plugged/Unplugged
Sensor Calibration (advanced information’s)
• BM Sensor Calibration Value - (Backup value)
• BM offset: value of offset setting
• Mark Distance: „x.x mm“