Specifications

Programmers Guide TH230/TH230+
260
Software
Menu
Nr.
Description Available Options
4.3.1 Exit
Exit this menu level and give a save request, if
there are unsaved changes.
4.3.2 Power-ON Notice
Select a power up notification on the
communication interface
Transmit,
Don’t Transmit
4.3.3 Paper-NE Notice
Select the usage of the Paper-Near-End Sensor. If
Paper-NE notification is dis
abled, the printer
doesn’t transmit the PNE state by ASB or state
request (ESC v)
Enable Paper-NE
Notice,
Disable Paper-NE
Notice
4.3.4 Automatic Line Feed
Generate a line feed after receiving <CR>.
(see page 98 – GS ( E fn3)
Enable Automatic Line
Feed,
Disable Automatic Line
Feed
4.3.5 No. of Endurance Tickets
Select the number of endurance tickets in for a
limited endurance test.
Print 1 Ticket,
Print 10 Tickets,
Print 30 Tickets,
Print 100 Tickets,
Print 1.000 Tickets,
Print 65.535 Tickets
4.3.6 Legacy Printer Support
Enable this to fully support Windows printer
support driver (e. g. Usbprint.sys). Following
changes in the printer behaviour will be made:
- printer doesn't accept data while receive
buffer is full (none data loss)
- in case of USB interface a fixed (virtual) serial
number is exposed to the host to avoid
multiple printer installations
Enable Legacy Printer
Support,
Disable Legacy Printer
Support
4.3.7 Listen To RT-Cmds
Behavior of the printer regarding Real Time
Commands. When set to always to printer listen
always to Real Time Commands. When set to
BufNotFull the printer listen only to Real Time
Commands when the receive buffer is not ful.
Listen To RT-Cmds –
Always,
Listen To RT-Cmds –
BufNotFull