Specifications

TH230/230+ Programmer’s Guide
257
Every diagnostic function will be explained in the table below.
Menu
Nr.
Description Available Options
3.1 Exit/Save
3.2 Endurance Test
This menu gives the ability to start the
endurance test with several conditions.
At first it is possible to start the endurance test
limited, which means the test will be performed
as many times as defined by the Customized
Value “Number of Endurance Tickets”.
In endless mode, the execution can be
interrupted by a long click of the LF button.
Run endless or
limited (Nr. of
Endurance
Tickets
Software  Number of
Endurance tickets)
3.3 Rolling Pattern Test
The rolling pattern menu allows you to print out
a rolling pattern in numerous ways.
You can print it out once, endless, which will be
interrupted by a long click of the LF button, and
a predefined number of times
1, 10, 50, 100, 500,
endless
3.4 Sensor Test
This function shows the sensor changes (See
page 273).
The Sensor Test can be stopped by pushing the
Linefeed button once for a long time (> 1
second). Afterwards a SW reset is executed.
3.5 Black Mark Test
In this menu the black mark test can be choose
(see page 277).
3.6 Cutter Test (Full Cut)
The cutter test performs some cutter operations
for a predefined number of times.
In endless mode, the test will be interrupted by a
long click of the LF button.
For every cut there will be a notice on the
generated ticket which gives information about
the current number of cuts and the total number
of cuts.
1, 10, 50, 100, 500,
endless mode
3.7 Cutter Test (Half Cut)
This test is the same like the cutter test (full cut),
but the printer performs a series of partial cuts.
1, 10, 50, 100, 500,
endless mode