Specifications

Programmers Guide TH230/TH230+
256
Exit
This command leaves the service menu. If there are changes of one or more unsaved
settings, the user will be asked for saving. After that, the printer will perform a warm
reboot.
Print Selftest
By using this command the printer performs a self test printout. It is the same function like
started by the “(US) t” sequence or in iPRINT when closing the cover while pressing the
Linefeed button. A detailed description how statistical information is saved can be found
on page 278.
In case of paper out during printing, the printer performs an automatic reset.
Diagnostic - Menu
The diagnostic menu gives you the ability to do some basic diagnostic. You can print out
some endurance or rolling pattern tickets. You also can perform a sensor, a cutter and a
black mark test.
Diagnostic
(See chapter x.x.x)
1
Exit
2
Endurance Test
3
Rolling Pattern Test
4
Sensor Test
5
Black Mark Test
6
Cutter Test (Full Cut)
Endurance Test
1
Exit
2
Run Test Unlimited
3
Run Test Limited
Rolling Pattern Test
1
Exit
2
Print Pattern Once
3
Print Pattern Unlimited
4
Print Pattern 10 Times
5
Print Pattern 50 Times
6
Print Pattern 100 Times
7 Print Pattern 500 Times
Cutter Test Full Cut
1
Exit
2
Perform Single Cut
3
Perform Unlimited Cuts
4
Perform 10 Cuts
5
Perform 50 Cuts
6
Perform 100 Cuts
7
Perform 500 Cuts
Start Sensor Test
Start Black Mark Test
Main Menu
2
Print Selftest
3
Diagnostics
4
Configuration
5
Information
6
MF Menu*
1
Exit
Cutter Test Partial Cut
1
Exit
2
Perform Single Cut
3
Perform Unlimited Cuts
4
Perform 10 Cuts
5
Perform 50 Cuts
6
Perform 100 Cuts
7
Perform 500 Cuts
7
Cutter Test (Half Cut)