Specifications

TH230/TH230+ Programmers Guide
197
Printer Parameter Table
The following table shows the possible adjustments and how it can be changed.
Parameter
Possible Value
Max. Value
Influenced by Default
BM sensor Enabled, Disabled GS ( E Disabled
Endurance Test Enabled, Disabled GS ( E Disabled
Serial number 0 – 4294967295 GS ( E (fn = 129) 0
Serial number date YYMMDD GS ( E (fn=130) 0
Paper width 80 mm, 82,5 mm GS ( E (fn=5) 82,5 mm
Print density 50 % - 130 % GS ( E (fn=5) 100 %
BM adjustment value
offset
0 – 255 GS ( E (fn=5)
Depends of the printer
hardware
Sensor values 0 – 255 GS ( E (fn=5)
Depends of the printer
hardware
Maximum power Auto or 48 W – 110 W GS ( E (fn=5) Auto
Maximum speed 70 – 220 mm/sec GS ( E (fn=5) 220 mm/sec
Max speed TH230+ Draft 70 – 300 mm/sec GS ( E (fn=5) 220 mm/sec
Number of Endurance test
tickets
1 – 65535 Tickets GS ( E (fn=5) 100 Tickets
Paper selection
Single color, Two
color
GS 0x81 Single color
Firmware version 00.00 - 99.99 no
Depends of the
firmware version
Maintenance
Counter for the
whole printer
life.
Linefeeds
(total)
0 - 4294967295 no 0
Dots (total) 0 - 4294967295 no 0
Cuts (total) 0 - 4294967295 no 0
Firmware
start cycles
0 - 4294967295 no 0
Power on
hours
0 - 1000000000 no 0
EEPROM
update cycles
0 - 4294967295 no 0
Cutter Errors 0 - 65535 GS g 0 0
Black Mark
Errors
0 - 65535 GS g 0 0
Thermistor
Errors
0 - 65535 GS g 0 0
Low Voltage
Errors
0 - 65535 GS g 0 0