Specifications

Programmers Guide TH230/TH230+
194
GS 0xFF
Function:
Reset firmware
Code ASCII: GS 0xFF
Code HEX: 0x1D 0xFF
Description:
Ends the load process and reboots the printer. Before executing this
command, the printer should have firmware loaded and external switches
set to the runtime settings. Application software for downloading should
prompt the user to set the external switches and confirm before sending this
command. If the downloading was started from a diagnostic, the reboot will
cause the printer to re-
enter download state unless the external switches are
changed.
NOTE: PON will not be send by using LAN-Interface
US EOT
Function: Convert 6-dots/mm bitmap to 8-dots/mm bitmap
Code ASCII:
US EOT n
Code HEX:
0x1F 0x04 n
Range: 0 = Off
1 = On
Default: n = 0 (Off)
Description: Selects or cancels 6-dot/mm emulation mode.
When the 6-dot/mm emulation is selected, logos and graphics are expanded
horizontally and vertically during download to emulate their size on a 6-
dot/mm printer. The horizontal positioning commands also emulate
positioning on a 6-dot/mm printer.
US ENQ
Function: Select superscript or subscript modes
Code ASCII: US 0x05 n
Code HEX:
0x1F 0x05 n
Range: n = 0 = Normal character size
n = 1 = Select subscript size
n = 2 = Select superscript size
Default: n = 0 (normal size)
Description:
Turns superscript or subscript modes on or off. This attribute may be
combined with other characters size settings commands (0x12, 0x13, 0x1B
0x21 n, 0x1D 0x21 n,…)
Notes:
• This command is ignored if n is out of the specified range.