Specifications

Programmers Guide TH230/TH230+
150
135 Print line resolution “_203 dpi”
136 Character generator checksum
result
String “_OK” or “_Err”
143 Booter version String with 6 characters
“_xx.xx”
144 Loader version String with 6 characters
“_xx.xx”
145 Poweruptest version String with 6 characters
“_xx.xx”
146 Poweruptest
checksum result
“_OK” or “_Err”
148 EEPROM status “_OK” or “_Err”
149 Loader verified status “_Verified” or “_Unverified”
157 Print Line Type “_A” (ROHM thermal print
line) or “_B” (other
manufacturer)
158 Interface Board Description String with the name of the
interface board. (see
example below)
159 Interface Board Type String with the type of the
interface board. For example
“_02” or “_10” (see site
Fehler! Textmarke nicht
definiert.)
160 Number of Colors String with the number of
colors For example “_1” or
“_2”
161 ASIA-Character generator name String with max 17
characters
162
ASIA-Character generator
version
String with 6 characters
(_xx.xx)
163
ASIA-Character generator
checksum result
String “_OK” or “_Err”
254
Sensor Plug Info
String “_xxxxxxxx”
(See table below)
255 Measured Mark Distance String with max. 12
characters “_xxxxx steps”
* TH230 (predecessor of TH230+) sends the Bare PCB Number (“_A”..”_Z”)
Notes:
• The ID of the printer is transmitted when the data in the receive buffer is
developed. Therefore, there may be a time lag between receiving this
command and transmitting the status, depending on the receive buffer
status. This means that this command is no real time command
. Therefore
this command doesn’t work while the printer is in the Offline State.
• n = 1, 2, 3: In this case the printer sends 1 byte of data.