Specifications

Programmers Guide TH230/TH230+
144
Notes:
• This command is ignored if a downloaded bit image has not been defined.
• When standard mode is selected, this command is enabled only when
there is no data in the print buffer. If data exists in the print buffer, the
printer processes m as normal data.
• When page mode is selected, this command develops the downloaded bit
image data in the print buffer but the printer does not print the
downloaded bit image data.
• If a downloaded bit image exceeds one line, the excess data is not
printed.
• This command feeds as much paper as is required to print the
downloaded bit image, regardless of the line spacing specified by ESC 2 or
ESC 3.
• The downloaded bit image is not affected by print mode (emphasized,
double-strike, underline, character size, white/black reverse printing, or
90° clockwise-rotated upside-down printing mode).
• The downloaded bit image is defined by GS ✻.
• Downloaded bit image is printed in the default dot density (dot density of
vertical and horizontal direction in normal mode) defined by GS L
<Function 49>.
• After printing the downloaded bit image, the printing position is set to
the left of the printing area. The printer is in the beginning of a line and
data is not in the print buffer.
• Modes that can be specified and relation of the magnification of the print
result are as follows:
This printer does not support the GS ( L/GS 8 L graphics function. The
values of [Dot Density] and [Maximum Print Area (dot)] are the same as
for graphics function GS ( L/GS 8 L of Function 69.
M Mode
Magnification
Width
Height
0, 48 Normal 1 times 1 times
1, 49 Double-width double 1 times
2, 50 Double-
height
1 times double
3, 51 Quadruple double double