Specifications

TH230/TH230+ Programmers Guide
121
• The adjustment value for the print starting position (a = 1) is affected by
the command FF
• (see page 24). The value “0” means cut below of the mark position.
• The print start position is relative to the lower edge of the detected
mark.
• This command is stored in the receive buffer first from the host, and
then executed in the execution process of other normal commands.
Therefore, there may occur time delay for the execution of this
command after the printer receives this command. The delay time
depends on the status of the receive buffer.
If the adjustment value greater than the paper mark distance, printer feed
only the remainder between adjustment value and mark distance + mark
width (separator value modulo (mark distance + mark width)). For example,
if the separator value is 180 mm and the mark distance 70, the feed after
the mark will be 30 mm.
Notes:
•
Please note that the maximum paper feeding amount can not be greater
than the distance between two black marks