Specifications

Programmers Guide TH230/TH230+
108
• a = 6: The cutting position behind a black mark can be adjusted by an
internal correction value which is restored after every power-on. (Refer
to GS_(_F); Bit 7 is used as direction bit, Bit 6 – Bit 0 as offset value.
• a = 9: If maximum power setting “Auto” is selected, the printer detects
the power of the connected power supply automatically. This works with
all power supplies from Wincor Nixdorf.
If a power supply from another manufacturer is used, the maximum
power setting has to be adjusted to the value of the used power supply
e.g. 55W, 75W, 90W or 110W.
• a = 9: If the setting “Auto” is selected and no WINCOR-NIXDORF power
supply is used, the printer responds with the string “ID-FAIL 48” and
selects 48 Watt (command GS ( E (fn = 6) see page 109). In this case the
user has to set a fix maximum power setting according to the used power
supply. To indicate this condition the green Power LED is blinking (see
page 5).
• a = 9: If the setting “Auto” is selected and the interface card is an
PoweredUSB type, then the printer selects 75 Watt automatically. Of
course this value can be changed by the command GS ( E (fn = 6) see
page 109).
• a = 9: Please note that reducing the maximum power setting leads to a
bad performance of print speed and print quality.
• a = 10: The maximum speed setting depends from the inserted paper.
• a = 12: This setting is the density of the color, which is different to black
(red, green, blue).
• a = 18: This setting is available only for the BEETLE /iPrint system.