Specifications

TH230/TH230+ Programmers Guide
107
Default character code table after Reset (a=16)
(n
L
+ n
H
* 256)
Code Page
Default
0 … 255 Equal to ESC t n 0 (PC437)
This value sets the Code Page number that is used after switch on the
Printer or after use the sequence ESC @.
• This value should be set to a value which is listed at ESC t n (see page 74).
If it is not listed in ESC t n then a Value of 0 is taken.
• Sometimes it is not possible to change the application program and in
addition the application program needs a code page which is different to
PC437. This custom value is used to set a specific start code page without
changing the application program.
Auto Recovery (a=17)
(n
L
+ n
H
* 256)
Auto Recovery Mode
Default
0 Off 0 (Off)
1, 2 Equal to DLE ENQ n
This value sets the Auto Recovery Mode that is executed in error condition
by closing the Cover. The Mode is the same like DLE ENQ n and mines
0: No Recover
1: Recover without clearing
2: Recover with clearing
Power On Behavior (a = 18):
This custom value is only available in iPRINT.
(n
L
+ n
H
* 256) Power On Behavior Default
0 Restore last state before power fail
0
1
System is always switched on
2
System is always switched off
Notes:
• This function works only in user setting mode.
• To activate the customized values you set with this function, you must
transmit a Function 2 command.
• Customized value can be specified by the unit of 3 bytes [a n
L
n
H
].
• Example: Transmit data when changing the paper width to 57.5 mm
ASCII: GS ( E pL pH fn a n
L
n
H
Hex: 0x1D 0x28 0x45 0x04 0x00 0x05 0x03 0x02 0x00
• The setting value of the print speed is effective when the printer
performs in proper condition. Print speed may slow temporarily,
depending on the operating environment or the print duty.