Specifications

TH230/TH230+ Programmers Guide
105
Color density settings (a = 12):
(n
L
+ n
H
* 256) Print density Default
-10 (65526) 50 %
100 %
-9 (65527)
55 %
-8 (65528)
60 %
-7 (65529)
65 %
-6 (65530) 70 %
-5 (65531) 75 %
-4 (65532) 80 %
-3 (65533)
85 %
-2 (65534)
90 %
-1 (65535)
95 %
0 100 %
1 105 %
2 110 %
3 115 %
4
120 %
5
125 %
6
130 %
Receipt shooting flush time (a=13)
(n
L
+ n
H
* 256)
Flush time
Default
0
Endless
0
1 … 255 Time in 0.25 sec
This value sets the time how long the printer is waiting for print
commands from the host before the receipt is printed out. The value
must be multiplied by 250 milliseconds (i.e. CV13 = 8 -> Receipt shooting
flush time = 2 sec).
The range is from 1 to 255 (250 ms to 63,75 seconds) or 0 for endless
(default).
If the Memory Switch for receipt shooting (128-5 / see page 98) is
disabled the printer ignores this time.
If the host sends a cut or graphics command the receipt is printed out
(Logo’s are buffered). The buffered data can also be printed out by the
sequence ESC w n 7 (see page 77). After this the host have to wait for
the answer of ESC w n 7.
NOTE: If both Receipt shooting and Sleep-Mode are enabled and the
Sleep-Mode time
is equal or smaller than the shooting time the buffered
Receipt is not printed out in Sleep-Mode.
NOTE: The Receipt shooting spooler is flushed if the command “Set
control point” is used.