Specifications

TH230/TH230+ Programmers Guide
99
When a = 128, memory switch 128 is set as follows:
Msw Setting Value (b) Function
128-1 48 Power button is enabled
49
Power button is disabled
128-2 48 In Sleep-Mode is Interface Power On
(only TH230+)
49 In Sleep-Mode is Interface Power Off
(only TH230+)
128-3 48 Sleep-Mode enabled
49
Sleep-Mode disabled (default)
128-4
48
Legacy printer support disabled *
49
Legacy printer support enabled *
128-5
48
Receipt shooting is disabled
49 Receipt shooting is enabled
128-6 48 Paper-Near-End Sensor Notification in
ASB and printer status will be send
49 Paper-Near-End Sensor Notification in
ASB and printer status will be suppressed
128-7
48
Black mark sensor is disabled
49 Black mark sensor is enabled
128-8 48 Original Controller: Yes
49 Original Controller: No
* The printer must be switched off and on to take effect of changed setting!
Notes:
• This function works only in the user setting mode.
• The value of the memory switch is specified from bit 8 to bit 1 by
b1
8
...b1
1
. When b = 50, the status of the bit applied is not changed.
Example:
Transmission data that specifies memory switch 128, “Power button is
disabled” and does not change other settings.
ASCII: GS ( E pL pH fn a b8 b7 b6 b5
b4 b3 b2 b1
Hex: 0x1D 0x28 0x45 0x0A 0x00 0x03 0x80 0x32 0x32 0x32 0x32
0x32 0x32 0x32 0x31
• Explanation for memory switch 1 (a = 1):
Power-on
notification
Hex Decimal Data quantity
Header
0x3B
59
1 byte
Identifier 0x31 49 1 byte
NUL 0x00 0 1 byte