Specifications

Programmers Guide TH230/TH230+
94
GS ( E
Function: User setup commands
Code ASCII: GS ( E p
L
p
H
fn parameters
Code HEX:
0x1D 0x28 0x45 p
L
p
H
fn parameters
Description: Controls the user setting modes. The table below explains the functions
available in this command.
• The value of fn specifies the function.
fn Function Description
1 Function 1 Changes into the user setting mode.
2 Function 2 Ends user setting mode session. (Performs a
software reset.)
3 Function 3 Changes the memory switch.
4 Function 4 Transmits the host the value for the memory
switch.
5 Function 5 Changes the customized setting values.
6 Function 6 Transmits the customized setting values.
11 Function 11 Sets communication condition of serial interface.
12 Function 12 Transmits communication condition of serial
interface.
129 Function
129
Set serial number
130 Function
130
Set production date
131 Function
131
Sets communication condition of Ethernet
interface
132 Function
132
Transmits communication condition of Ethernet
interface
• p
L
and p
H
specify the number of bytes for the parameters following
p
H
(fn and [a1 b1] ... [ak bk]) as (p
L
+ (p
H
× 256)).
• The other parameters are explained under the respective functions.
Notes:
• The value of parameter fn determines the function number for this
command. Command operation differs, depending on the function
number.