Specifications

11-28
MiniScan MS-320X Integration Guide
Setup Field(s)
Table 11-1. Setup Field(s) Definitions
Parameter Description Page
Move Cursor
Move Cursor To a Character Scan the Move Cursor To Character bar code
on page 11-29, then any printable ASCII
character from the Alphanumeric Keyboard.
When this is used, the cursor moves to the
position after the matching character. If the
character is not there, the rule fails and ADF
tries the next rule.
11-29
Move Cursor to Start of Data Scan this bar code to move cursor to the
beginning of the data.
11-29
Move Cursor Past a Character
This parameter moves the cursor past all
sequential occurrences of a selected character.
For example, if the selected character is ‘A’,
then the cursor moves past ‘A’, ‘AA’, ‘AAA’, etc.
Scan the Move Cursor Past Character
bar
code on page 11-29, then select a character from
the Alphanumeric Keyboard. If the character is
not there, the cursor does not move (i.e., has no
effect).
11-29
Skip Ahead “N” Characters
Scan one of these bar codes to select the
number of positions ahead to move the cursor.
11-30
Skip Back “N” Characters
Scan one of these bar codes to select the
number of positions back to move the cursor.
11-31
Send Preset Value
Send Values 1 through 6 by scanning the
appropriate bar code from Prefix/Suffix Values
on page 7-108. These values must be set using
the prefix/suffix values in Table A-1 on page A-1
and Table A-2 on page A-7.
Value 2 = Scan Prefix
Value 1 = Scan Suffix 1
Value 3 = Scan Suffix 2
11-32