Specifications

7-124
MiniScan MS-320X Integration Guide
Host Character Time-out
Parameter # EFh
This parameter determines the maximum time the decoder waits between characters
transmitted by the host before discarding the received data and declaring an error. The
time-out is set in 0.01 second increments from 0.01 seconds to 0.99 seconds. After
scanning the bar code below, scan two bar codes beginning on page 7-143 to set the
desired time-out. To change the selection or to cancel an incorrect entry, scan the Cancel
bar code on page 7-145.
Host Character Time-out
Event Reporting
The host can request the decoder to provide certain information (events) relative to the
decoder’s behavior. Enable or disable the events listed in Table 7-3 by scanning the
appropriate bar codes on the following pages. Parameter number format for these
parameters follows those shown in the Simple Serial Interface (SSI) Programmer’s Guide
for parameters numbered 256 or higher.
Table 7-3. Event Codes
Event Class Event Code Reported
Decode Event Non parameter decode 01h
Boot Up Event System power-up 03h
Parameter Event Parameter entry error
Parameter stored
Defaults set (and parameter event is enabled by default)
Number expected
07h
08h
0Ah
0Fh