User guide

TH210-3 for MF

_____________________________________________________________________

_________________________________________________________

Code (Hexadecimal) Command

1B 4A n Print and Feed Paper

1B 4B n1 n2 d1...dn Select Single-Density Graphics

1B 4C Select Page Mode

1B 52 n Select International Character Set

1B 53 Select Standard Mode

1B 54 n Select Print Direction in Page Mode

1B 56 n Select or Cancel 90 Degree Clockwise

Rotated Print

1B 57 n1, n2...n8 Set Print Area in Page Mode

1B 59 n1 n2 d1...dn Select Double-Density Graphics

1B 5C n1 n2 Set Relative Print Position

1B 61 n Select Justification

1B 63 33 n Select Paper Sensors to Output Paper

End Signals

1B 63 34 n Select Sensors to Stop Printing

1B 63 35 n Enable or Disable Panel Button

1B 64 n Print and Feed n Lines

1B 69 Perform Full Knife Cut

1B 6A k Read from Non-Volatile Memory

1B 6D Perform Partial Knife Cut

1B 70 n p1 p2 Generate Pulse to Open Cash Drawer

1B 73 n1 n2 k Write to Non-Volatile Memory (NVRAM)

1B 74 n Select Character Code Table

1B 75 n Request Alternate Status

1B 75 0 Transmit Peripheral Device Status

1B 76 Transmit Paper Sensor Status

1B 7B n Select or Cancel Upside Down Print Mode

1D 00 Return Boot Sector Firmware Part Number