User manual

In the next screen, you can enter the graphics adapter you are using
(mono for the cashier display or VGA for the monitor).
If there is no VGA adapter, the display entry must be set to
MONO or OPERATOR (80486DX2 and higher) to make
the outputs appear on the cashier display.
If you press key (7), you terminate configuration by restarting the system.
Additional I/O adapters
In the case of an 80486DX2 system, up to two interface adapters can be
installed (addresses 3F8 and 2F8). The on-board interfaces are then deac-
tivated automatically.
You only see the following screen in the setup menu of BEETLE systems
that have an 80486DX2 processor and a hard disk with more than 1023
cylinders. As of this size, the hard disk data must be handled differently by
the BIOS and the MS-DOS operating system.
Display Operator
(5) Help
(8) Prev (6) Incr
(2) Next (4) Decr
Port 3F8 Enabled
(5) Help
(8) Prev (6) Incr
(2) Next (4) Decr
BIOS setup
GB - 89