User manual

Remove any dirt and
dust from the opening
using a soft paint
brush. The sensor can
also be cleaned using
compressed air.
Press the ribbon cas-
sette into the holder.
Finally close the receipt/journal guide and the upper POS housing.
Cleaning the printer motor timing disk
Dust and dirt on the printer motor timing disk may lead to print malfuncti-
ons. It is therefore necessary to clean the timing disk at regular intervals.
Frequency of cleaning depends on the respective ambient conditions.
Clean the timing disk as described below. If the malfunction persists, con-
tact your appropriate Service Division.
Open the front screen of the POS housing. To open the upper section of
the housing, gently press against the housing cover from the inside and
fold back.
Thetimingdiskisloca-
ted at the right of the
printer unit behind a re-
cess (see illustration).
stamp
timing disk
Care and cleaning
GB - 60