User manual

Changing the printer

To change the printer, open the paper compartment cover. Then discon-

nect the printer cable from the rear of the printer housing.

Loosen the knurled screw indicated by an arrow in the drawing below.

Now lift the printer a little at the front and pull it forward over the larger re-

cess, and lift it up. There will still be a cable connected to the underside.

Disconnect this, and remove the printer.

When installing a printer, remember the following:

You must connect the power cable to the underside.

The two projections on the rear of the printer must fit into the corre-

sponding recesses in the terminal housing.

Do not jam the cable!

Once you have inserted the printer, push it back until the knurled

screw is in the narrower recess. Tighten the knurled srew.

Do not forget to plug in the printer cable.

Two-stations printer Changing the printer

GB - 55