User manual

Next, return the spool
to the guide so that the
gear wheels of the roll
and drive engage
correctly.
Do not use the advance button to insert the receipt paper.
Tear off the surplus receipt paper and shut the paper compartment cover.
The POS system is again ready for operation.
Adjusting the paper end detectors
Adjusting the paper end detectors
The paper end detectors detect when the paper is almost gone by measu-
ring the diameter of the paper roll.
If you want to change the amount of paper remaining when the printer
stops printing, follow the steps below:
Open the housing cover and remove the paper roll.
Determine the point on the paper roll at which you want the paper roll
end detection to be triggered. Then measure the distance A shown in
the illustration.
Abstand A
Distance A
Two-stations printer Adjusting the paper end detectors
GB - 47