User manual

Changing the printer

To change the printer, open the paper compartment cover, and tilt the

cashier display forward. Then disconnect the printer cable from the rear of

the printer housing, loosen the knurled screw indicated by an arrow in the

drawing below. Now lift the printer a little at the front and pull it forward

over the larger recess, and lift it up. There will still be a cable connected to

the underside. Disconnect this cable and remove the printer.

When installing a printer, remember the following:

■ You must connect the power cable to the underside.

■ The two projections on the rear of the printer must fit into the corre-

sponding recesses in the terminal housing.

Do not jam the cable!

Once you have inserted the printer, push it back until the knurled screw is

in the narrower recess.

One-station printer Changing the printer

GB - 37