User manual

Before switching the system on
Unpacking and checking the delivery
Before switching the system on
Unpack everything, and check that what has been delivered corresponds
to what is specified on the delivery note.
If you find that anything has been damaged during transportation or that
there are differences between the delivery and what is on the delivery
note, please notify your SNI branch or dealer immediately. We re-
commend that you keep the original packaging in case you want to trans-
port the device again (the packaging protects it against knocks and
bumps).
Always take hold of the sides of your BEETLE /20 and ne-
ver of the cable cover or the keyboard as both are movable
and can be removed without any tools
Setting up the device
Set up the BEETLE POS system where it will not be subjected to extreme
ambient conditions. Protect it from shocks, dust, moisture, heat and power-
ful magnetic fields.
Make sure that the ventilation slots at both sides of the
BEETLE POS system are clear (at least 50 mm on both si-
des) to ensure that the device has adequate ventilation.
Cabling the BEETLE
Install the devices in the following order:
Ensure that the device is switched off before you connect the cables.
Connect the power cable to the BEETLE /20.
Connect the plug of the power cable to a grounded-contact utility po-
wer socket.
Before switching the system on
GB - 12