User manual

Error messages via blink codes (one station printer)
Error detection
The printer can be recovered from an error state by turning off the power,
correcting the error and then turning the power back on.
The DTR interface single is set to MARK, i.e. data entry is prohibited (seri-
al I/F) and the printer automatically goes OFF-LINE.
Error display
The printer error is indicated by the ON-LINE indicator.
The following table lists the indicator states:
Error Light flashing pattern (1sec) Content
Printer Error
The timing signal can not be
detected that is caused by printer
when the motor starting.
Online/ Error
Power
Paper feed button
500 500 msec
O
n
O
ff
Error messages
GB - 116