User manual

Changing the hard disk
Appendix Changing the hard disk
It is also easy to change the hard disk of the BEETLE/20. Begin by
removing the keyboard (see the section on installing an expansion
card on page GB - 100). Then remove the screw indicated by an arrow in
the drawing below.
Push back the cover
plate to the terminal´s
housing, and lift it out.
You will then be able
to see the card.
Undo the screw indica-
tedbyanarrowinthe
drawing beside.
Push the hard disk to the left a little, then lift it a little at the front and pull it
towards you. You will be able to see the two connectors on the rear of the
hard disk. Disconnect these, and remove the hard disk.
To install the new hard disk, proceed as decribed above but in the reverse
order.
Changing the hard disk Appendix
GB - 106