User manual

Installing an expansion card
All the expansion slots are for half-size expansion cards. To install an ex-
pansion card, you first have to remove the slot´s metal cover. Remove the
screw by which the cover is attached the BEETLE/20. It is easy to remove
the cover.
Be carefull not to let the cover fall on the CPU board. This
could cause a short circuit, since the CPU components are
still supplied with power by the system accumulator battery.
If the card has any jumpers, check that they are set correctly. To find out
the correct settings, refer to the card´s documentation. Then insert the ex-
pansion card inthe slot provided. Ensure that the card is firmly in position.
Secure the card with the screw that you removed from the cover.
screws
Appendix Installing an expansion card
GB - 103