User guide

With an installed TFT adapter and activated Touchscreen function the
COM4* is no longer available. Settings for (de-) activating this function are
made in the BIOS setup.
RJ10/RMT
You connect the Power Save Interface (also remote (RMT) interface) of
your POS system via a cable to the acc. interface of the display (BA82/83).
Use the Power Save function by pushing the ON/OFF button of the display.
This function enables you to wake up a BEETLE system out of either
standby/ hibernation or soft-off mode. It also puts a running system into
standby / hibernation mode. The activated mode is depending on the
settings of the operating system.
P-USB (Po we red USB)
The P-USB interface is qualified for connections of peripheral devices such
as printers, barcode scanners or customer displays.
The power supply is either 12V or 24V (marked red, for POS printers).
A mechanical code avoids the plugging of a USB 12V connector into a USB
24V jack.
Always use this onboard P-USB 12V (*) to connect a BA82 or BA83 with
additional options or any other multifunctional screens.
USB (Uni ver sal Se ri al Bus)- A (USB 2.0)
You can connect several USB peripheral devices e.g. scanner or scales to
the USB.
Only connect devices equipped with a shielded cable to the USB-interfaces.
LAN (RJ45)
A connection to a network (LAN) is available at the connector panel of your
BEETLE, see page 21.
BEETLE /M-II plus 23