User guide

 Power output (not in option 2)
 Power switch (not in option 2)
 Power connector
 DC24V (Printer)
 RJ12 (Cashdrawer)
At the front side of the system find the ON/OFF button which will turn on and
off the system (Option 1: Power Switch at the rear side in position 1).
Switching off during operation is possible (press button again for approx. 5
sec.). The exact function of this button is controlled by the settings in your
operating system and the BIOS.
The power pack must be removed or replaced by authorized qualified
personnel only. Only replace power packs released by Wincor Nixdorf.
To disconnect the device from the supply voltage completely, switch off the
device and disconnect the power plug.
Po wer Con nec tor
This connector provides the power. Connect the according end of the power
cable to this port and the other end to the power socket.
Pull the mains plug to power-off the device.
Po wer Out put (not in op ti on 2)
The power supply for external devices (e.g. analogue monitor) is provided
by the power output socket.
BEETLE /M-II plus 19