User guide

The hard disks can be configurated automatically in SETUP. The
necessary parameters are read from the hard disk and stored in the
CMOS RAM. Your POS system offers two interfaces to connect hard
disks and other IDE drives (e.g. CD ROM drive), a PRIMARY port and a
SECONDARY port.
You can connect two drives to each port, a MASTER- and a SLAVE drive.
To use the SECONDARY interface, the Secondary IDE must be set to
“Enable”.
The following masks show an example of possible configurations for a
hard disk that is connected to a PRIMARY SLAVE port.
PRI MASTR AUTO
(8)Prev (6)Incr
(2)Next (4)Decr
PRI SLAVE AUTO
(8)Prev (6)Incr
(2)Next (4)Decr
PRI SLAVE NONE
(8)Prev (6)Incr
(2)Next (4)Decr
SEC MASTR NONE
(8)Prev (6)Incr
(2)Next (4)Decr
SEC SLAVE NONE
(8)Prev (6)Incr
(2)Next (4)Decr
Secondary IDE
Disable
(8)Prev (6)Incr
(2)Next (4)Decr
(2)
A
(4)
(6)
(4)
(2)
(2)
(2)
PRI SLAVE TYPE 1
(3)List Params
(8)Prev (6)Incr
(2)Next (4)Decr
Cyl 306 Head 4
Sec 17 10MB
Any Key to Return
(3)
(...)
Enable (2)
(2)
(2)
Disable (2)
next
menue
BIOS setup
GB - 66