User guide

The following media can be assigned a drive:
Starting up the system Start and runup behaviour
❚ Disk
❚ BEETLE card
❚ Network
❚ Hard disk
The logical drives are designated A:, B:, C: and D:.
If the system is to be booted from disk (BEETLE card), this medium
must always be assigned drive A:. It is also possible, however, to
assign B: to the disk if you wish to use the card as a pure storage
medium. The network is always assigned to the C: drive during the
runup procedure. The hard disk can be assigned to the C: or D: drive.
The system can only be started from the hard disk if the disk has been
configured as the C: drive.
The modular BEETLE /M POS system can be booted from two drives.
However, please note the following restrictions:
❚ The system can be booted from drives A: and C: only.
❚ The storage medium must be system-boot-capable.
The following priorities apply:
The POS system always attempts to boot from a disk first if they are
inserted in the respective drive.
Floppy disk (A:) High priority
BEETLE card
Network (C:) Medium priority
Hard disk (C:) Low priority
Start and runup behaviour Starting up the system
GB - 60