User guide

Monitor
If a VGA board is installed, you can connect a monitor to the
BEETLE /M via the 15-pin D-sub jack on the VGA board. Power is
supplied to the monitor via the rubber connector on the BEETLE /M,
located on the back of the housing.
Connecting standard PC peripherals (COM1)
You can connect supplementary standard peripherals to the
BEETLE /M via the COM1 serial interface.
Make sure that all supplementary devices have been tested for RFI
suppression pursuant to the legal requirements of your country.
Network
If a network board is installed, the system can be connected to a
network (LAN) from the POS terminal back panel. If a LAN board is not
installed, this location on the back panel is closed by a dummy cover
(see also Configuration variants).
Connecting peripherals The individual POS System
GB - 24