User guide

Starting up the system
After installing the BEETLE /M-II, switch on the POS system using the
ON/OFF button on the front panel and the power switch on the power
supply.
The system first performs an automatic self-test to test its basic functions.
For example, you may see the following message (irrespective of processor
type) on the monitor:
xx/xx is the place holder of the BIOS version number
The system then determines the medium from which the operating system
and POS application are to be booted. Each medium is assigned a logical
drive according to the configuration of your BEETLE /M-II.
The following media can be assigned a drive:
n
Network
n
Hard disk
n
DVD-ROM
n
USB drive
The logical drives are designated C: and D:.
The network is always assigned to the C: drive during the runup procedure.
The hard disk can be assigned to the C: or D: drive. The system can only be
started from the hard disk if the disk has been configured as the C: drive.
Corresponding to the Setup configuration the modular BEETLE /M-II system
can be booted from the following drives:
STARTING UP THE SYSTEM
44
WN ID xx/xx Da tum