User guide
Table Of Contents
- Contents
- Manufacturer´s Certification 1
- Introduction 4
- BEETLE /M-II- the individual POS System 8
- BEETLE /M-II- the Components 26
- Configuration variants 38
- Starting up the system 44
- Appendix 46
Pull the tappet of the clamp (see fig.) and remove the metal cover.
Af ter ha ving pul led
the car rier of the
hard disk the re is
an easy ac cess to
the AT slots.
Ensure that the card establishes contact with the terminal strip. Plug the
power cord and if avaible plug the COM7 and COM8 data cables into the
PCI/COM card. Secure the card by tightening it with the screw that you have
removed before.
Following this, mount the POS housing again. The mains connector can
now be reconnected and the cable cover can be moved on the device.
Switch on the system at the front side.
IN STAL LING AN EX PAN SI ON CARD
42
tap pet of the clamp