User guide
Table Of Contents
- Contents
- Manufacturer´s Certification 1
- Introduction 4
- BEETLE /M-II- the individual POS System 8
- BEETLE /M-II- the Components 26
- Configuration variants 38
- Starting up the system 44
- Appendix 46
Net work
The system can be connected to a network (LAN) from the POS terminal
back panel.
Only connect shielded LAN cables as these offer a better protection in case
of interferences in a network.
Mo du lar prin ters
Appropriate POS printers can be connected via the low-voltage jack 24V,
max. 3A via non-UPS or 2A via UPS. A connecting cable with a HOSIDEN
plug is required for this.
Connect only cable to the 24V connector which are marked with DP-1 or
DP-2.
Do not connect the HOSIDEN plug when the system is turned on, this can
lead to an automatical reboot of the system.
USB (Uni ver sal Se ri al Bus)
You can connect several USB peripheral devices to the USB or powered
USB interface (12V or 24V).
12V 24V
CONNECTING PERIPHERALS
24