User guide
Table Of Contents
- Contents
- Manufacturer´s Certification 1
- Introduction 4
- BEETLE /M-II- the individual POS System 8
- BEETLE /M-II- the Components 26
- Configuration variants 38
- Starting up the system 44
- Appendix 46
USB Plus Power connectors are
locked upon insertion.
TFT connectors are locked upon
insertion.
Replace the cable cover after the cables have been mounted (see next
page).
Moun ting the ca ble co ver
The scope of supply of your BEETLE /M-II includes a cable cover. Before
mounting the device, you should first remove the cable openings where
necessary. This depends on the cables which you wish to lay.
Tools are not required as the plastic parts can be removed by hand.
MOUN TING THE CA BLE CO VER
16