User guide
Table Of Contents
- Contents
- Manufacturer´s Certification 1
- Introduction 4
- BEETLE /M-II- the individual POS System 8
- BEETLE /M-II- the Components 26
- Configuration variants 38
- Starting up the system 44
- Appendix 46
Cab ling of the BEET LE /M-II
Follow the steps below in the order given when installing devices:
n
Make sure that the power switch on the front of the housing is set to OFF,
i.e. that it visibly protrudes. You may have to open the slide in order to do
this.
n
If present, the cable cover must be removed.
In order to loose the cable cover, push it out off the guides marked with
arrows in the figure above.
n
Plug one end of the power cable into the power cord receptacle on the
BEETLE /M-II.
n
Plug the other end of the power cable into a grounded-contact power
socket.
n
Plug in and secure the data cable.
Al ways make sure that the sys tem is swit ched off when you do cab ling
works.
CAB LING OF THE BEET LE /M-II
14