User manual

RJ10/RMT (optional)
You connect the Power Save Interface (also remote (RMT) interface) of
your POS system via a cable to the acc. interface of the display (BA82/83).
Use the Power Save function by pushing the ON/OFF button of the display.
This function enables you to wake up a BEETLE system out of either
standby/ hibernation or soft-off mode. It also puts a running system into
standby / hibernation mode. The activated mode is depending on the
settings of the operating system.
P-USB (Po we red USB)
The P-USB interface is qualified for connections of peripheral devices such
as printers, barcode scanners or customer displays.
The power supply is either 12V or 24V (marked red, for POS printers).
A mechanical code avoids the plugging of a USB 12V connector into a USB
24V jack.
Al ways use this on bo ard P-USB 12V (*) to con nect a BA82 or
BA83 with ad di tio nal op tions or any ot her mul ti functio nal screens.
D- Sub- Jack po wer supp lied (COM2*-COM4*)
The interface connection is a 9-pin D-sub jack for scanner, user or customer
displays without own power supply.
Make sure that the con nec tor for the cus to mer dis play is scre wed firm ly to
the so cket to pre vent pos si ble mal functio ning. Po wer is supp lied via this
jack.
22 BEETLE /S-II plus