User guide

At the end of SETUP you will see the following mask:
In this menu you can define whether the configuration data of your POS
system will be initialized when the system is started:
Yes With the start of the system the old configuration data will be reset.
The Plug&Play function will detect the current configuration data.
The installed components are initialized by these data. Components
not able for Plug&Play have to be registered manually.
No The installed components and drives will be initialized with the existing
configuration data. There will be no updating with the start of the
BEETLE.
With the Plug&Play functionality the installed components are
detected and initialized automatically, if these components
support Plug&Play. Set “Yes” when you use a Plug&Play card
or when an old card is being removed. The reset is done
automatically.
To quit SETUP press the numeric key 7. Your POS system will be
rebooted.
Reset Config Data
No
(8)Prev (6)Incr
(4)Decr
BIOS setup
GB - 72