User guide

It is possible to use the parallel interface LPT1 in standard mode and in
the modes ECP (Enhanced Capability Port) and EPP (Enhanced Parallel
Port). The transfer modes EP and EPP allow a higher data transfer rate
(up to 2MB/s and up to 2,4 MB/s). Please make sure that the peripheral
devices do support these modes.
The choice can be done in the following mask:
If you are using printers from Wincor Nixdorf, please choose the
standard mode.
With power management you can save energy when your system is off
time. When “No” is set, the CPU operates with maximum speed, i.e. at full
power. If “Yes” is set, the power management facility is enabled.
LPT1 Mode
Standard
(8)Prev (6)Incr
(2)Next (4)Decr
PowerMan Yes
(8)Prev (6)Incr
(2)Next (4)Decr
BIOS setup
GB - 65