User guide

Please mind the following procedure for handling the hard disk:
Generally you should configurate your hard disk with the setting “AUTO”
(automatical configuration). The BIOS then detects the optimal parameter
settings for your system and these parameters are set. Whenever starting
the system you can read from the monitor the type of installed hard disk in
abbreviated form (Only when “AUTO” is set).
Alternatively you can configurate the hard disk with the setting “USER
TYPE”. With the subfunction “HD Get Params ?” the system tries to read
in the parameters of the hard disk. If this was not succesful you will have
to set all parameters step by step manually, according to the specification
of the hard disk.
If you have connected more than two hard disks you can enable the
Secondary interface by setting “Enable” . You can choose this in the
following mask:
Secondary IDE
Enable
(8)Prev (6)Incr
(2)Next (4)Decr
BIOS setup
GB - 64