User guide

The hard disks can be configurated automatically in SETUP. The
necessary parameters are read from the hard disk and stored in the
CMOS RAM. Your POS system offers two interfaces to connect hard
disks and other IDE drives (e.g. CD ROM drive), a PRIMARY port and a
SECONDARY port.
You can connect two drives with each port, a MASTER- and a SLAVE
drive. To use the SECONDARY interface, the Secondary IDE must be set
to “Enable”.
The following masks show an example of possible configurations for a
hard disk that is connected to a PRIMARY SLAVE port.
PRI MASTR AUTO
(8)Prev (6)Incr
(2)Next (4)Decr
PRI SLAVE
(8)Prev (6)Incr
(2)Next (4)Decr
PRI SLAVE
(8)Prev (6)Incr
(2)Next (4)Decr
SEC MASTR
(8)Prev (6)Incr
(2)Next (4)Decr
SEC SLAVE
(8)Prev (6)Incr
(2)Next (4)Decr
Secondary IDE
Disable
(8)Prev (6)Incr
(2)Next (4)Decr
(2)
A
(4)
(6)
(6)
(6)
(
(
4
4
)
)
(2)
(2)
(2)
PRI SLAVE
(3)List Params
(8)Prev (6)Incr
(2)Next (4)Decr
(3)
Enable (2)
(2)
(2)
Disable (2)
next
menue
NONE
AUTO
USER TYPE
AUTO
AUTO
BIOS setup
GB - 60