User guide

Installing an expansion card
First ensure that the device is switched off and that the power
connector is disconnected.
Please proceed as described in the section “changing the battery”
(page 37pp).
After having pulled forward the carrier of the hard disk and floppy disk
there is an easy access to the AT slots. Now remove the metal cover at
the housing by squeezing out one of the clambs (see picture).
You always should use the upper slot first.
This slot is - depending on the configuration -
reserved for a PCI-Card.
First check whether the jumpers (if present) of the card are set
correctly to avoid internal system conflicts. The correct setting for the
jumpers can be found in the documentation for the plug-in card. Then
slide the expansion card into the slot provided. Ensure that the card
establishes contact with the terminal strip.
Secure the card by tightening it with the clamb that you have removed
before (The pin of the clamb has to be put into the boring of the card).
Following this, mount the POS housing again. The mains connector
can now be reconnected and the device switched on.
Expansion cards with electrostatically sensitive devices
(ESD) can be marked with this sticker.
clamb
AT plug-in cards
GB - 47