User guide

Cabling of the BEETLE /M
Cabling of the BEETLE
Follow the steps below in the order given when installing devices:
Make sure that the power switch on the front of the housing
is set to OFF, i.e. that it visibly protrudes. You may have to
open the slide in order to do this (see figure on Page
GB - 17).
If present, the cable cover must be removed.
Plug one end of the power cable into the power cord
receptacle on the BEETLE /M.
Plug the other end of the power cable into a
grounded-contact power socket.
Plug in and secure the data cable.
Always make sure that the system is switched off when you
do cabling works.
Cabling of the BEETLE
GB - 14