Technical data

01750096993 E BEETLE iSPRINT POS System – Operating Manual 3
Important notes
The Modular POS system BEETLE iSPRINT conforms to the current
safety standards for data processing equipment.
 If this device is taken from a cold environment into the operating room,
moisture condensation may form. The device must be absolutely dry
before being put into service; an acclimatization period of at least two
hours must therefore be observed.
 This device is equipped with a safety-tested power cable and may be
connected only to a prescribed grounded-contact power socket.
 When setting up the device, ensure that the power socket on the device
and the grounded-contact power socket are easily accessible.
 To disconnect the device from the supply voltage completely, switch off
the device and disconnect the power plug.
 Ensure that no foreign objects (e.g. office clips) find their way into the
device, as this may lead to electric shocks or short-circuits.
 Never plug in or unplug data communication lines during thunderstorms.
 Protect devices from vibrations, dust, moisture and heat.
 Always dispose of used parts, such as battery in an environmentally safe
manner.
 In emergencies (e.g. damaged housing or damaged power cable,
penetration by liquids or foreign bodies), the device must be switched off
immediately, the power plug disconnected and the Customer Service of
Wincor Nixdorf (WN) or your dealer must be notified.
 The device may only be repaired by authorized qualified personnel.
Unauthorized opening of the device and inexpertly carried-out repairs
may not only seriously jeopardize the safety of the user, but also cancel
all the warranty and liability agreements.
 You should connect your
BEETLE
iSPRINT or other IT-devices to power
supply systems with separately guided protective earth conductor (PE).
This kind of electricity system is known as TN-S network. Do not use PEN
conductors!